丁二烯缓冲罐自聚物的生成原因及防范措施

分析了ABS树脂生产装置丁二烯缓冲罐中丁二烯自聚物的生成原因,提出了预防措施,避免丁二烯自聚物的生成,保证装置的安全平稳运行。     

天然胶/公共网络/废胶粉互穿聚合物网络

通过互穿聚合物网络技术成功制备了天然橡胶/公共网络/废胶粉共轭三组分,并测定了力学性能和微观形态。结果表明:当A/B摩尔比为2/1、AB含量为4.5%、废胶粉粒径为60目、废胶粉含量为15%时,体系的力学性能最好,共轭三组分天然橡胶/公共网络/废胶粉体系的磨耗体积明显低于两组分天然橡胶/废胶粉体系的磨耗体积。界面共轭互穿改善了界面结合,可减少反复压缩过程中的相间摩擦生热和变形。     

聚合物/表面活性剂二元体系对油水界面性质的影响

文章应用界面张力仪、Zeta电位仪和表面黏弹性仪测定了聚合物、表面活性剂及其二元复合体系的质量浓度对油水界面性质的影响,并应用透射电镜观察了采出液的液膜结构。结果表明,随着聚合物质量浓度的增加,油水界面的界面剪切黏度值和界面张力值增大,颗粒表面Zeta电位的绝对值增大;随着表面活性剂质量浓度的增加,油水界面的界面剪切黏度变化幅度很小,但界面张力显著减小,颗粒表面Zeta电位绝对值增大;聚合物与表面活性剂复合能够形成稳定的聚合体,具有较大的界面剪切黏度值,较小的界面张力和较高的Zeta电位值;体系中聚合物、表面活性剂及水中悬浮物形成了类似"晶体"结构。     

Extraction of heavy metals from e-waste contaminated soils using EDDS

Environmental contamination due to uncontrolled e-waste recycling activities is drawing increasing attention in the world. Extraction of these metals with biodegradable chelant [S,S]-ethylenediaminedisuccinic acid (EDDS) and the factors influencing extraction efficacy were investigated in the present study. Results showed that the addition of EDDS at low pH (5.5) produced higher metal extraction than that at high pH (8.0) solution. Metal speciation analysis indicated that Cu was completely complexed with EDDS at different pH conditions with various amounts of EDDS applied. For Pb and Zn, at low EDDS dose of 0.304 mol/kg soil, they were present as Pb- and Zn-EDDS. However, at high EDDS dose of 1.26 mol/kg soil, most of Pb was bound with dissolved organic matter. Ca and Al were found to be strong competitors for trace metals to EDDS at low application dose and low pH condition.     

Optimum conditions for the formation of Al13 polymer and active chlorine in electrolysis process with Ti/RuO2-TiO2 anodes

A polyaluminum containing a high concentration of Al₁₃ polymer and active chlorine (PACC) was successfully synthesized by a new electrochemical reactor using Ti/RuO₂-TiO₂ anodes. PACC can potentially be used as a dual-function chemical reagent for water treatment. The obtained results indicated that the formation of Al₁₃ polymer and active chlorine, were the most active components in PACC responsible for coagulation and disinfection respectively. These components were significantly influenced by electrolyte temperature, current density, and stirring rate. It was observed that high electrolyte temperature favored the formation of Al₁₃. Increasing current density and stirring rate resulted in high current efficiency of chlorine evolution, thus favoring the generation of Al₁₃ and active chlorine in PACC. When the PACC (Al_T = 0.5 mol/L, basicity = 2.3) was prepared at the optimum conditions by electrolysis process, the Al₁₃ polymer and active chlorine in product reached above 70% of Al_T and 4000 mg/L, respectively. In the pilot scale experiment with raw polyaluminum chloride used as an electrolyte, PACC was successfully prepared and produced a high content of Al₁₃ and active chlorine products. The pilot scale experiment demonstrated a potential industrial approach of PACC preparation.     

基于BDPs的多级土壤渗滤系统处理受污染河水的试验研究

针对受污染的流入滇池的河流河水,采用具有曝气段和缺氧段的两段式多级土壤渗滤(multi-soil-layering,MSL)系统,开展了在缺氧段添加非水溶性可生物降解多聚物(BDPs)材料PBS颗粒的强化脱氮除磷研究.结果表明,添加PBS碳源可有效解决传统MSL系统因碳源不足而导致的脱氮效果不理想的问题.在河水污染较轻及较重两种情况下,系统对TN的平均去除率分别达到78%、85%,平均单位表面去除负荷分别为9.09g·m-·2d-1、24.55g·m-·2d-1;TP平均去除率分别达到92%、98%,平均单位表面去除负荷分别为0.76g·m-·2d-1、2.02g·m-·2d-1.此外,系统对COD的平均去除率可达到75%以上.     

聚合铝铁对A2/O系统 EPS及生物絮凝性能的影响

通过向实验室构建的A2/O模型好氧池末端投加聚合铝铁(PAFC)来强化系统的生物除磷,使得出水总磷达到《城市污水处理厂污染物排放标准GB 18918-2002》中的一级A标准,并重点分析投加的PAFC对A2/O系统中活性污泥胞外聚合物(EPS)和活性污泥生物絮凝性能的影响.结果表明,随着PAFC投药量的增加,A2/O系统活性污泥EPS总量变化不大,但EPS组分中蛋白/多糖含量的比值逐渐降低,由投药前的3.30降低至投药后的2.30;EPS中金属离子含量逐渐增加,在厌氧-缺氧-好氧的运行周期内,各处理单元污泥的EPS中金属铝离子含量增加.投加PAFC后,活性污泥颗粒变大,二沉池出水的Zeta电位明显降低,由投药前-15.83 mV降低至-21.20 mV,污泥产量增加.因此,适量投加PAFC后,生物絮凝性能得到改善,出水中悬浊颗粒减少,出水水质变好.     

可生物降解材料聚羟基脂肪酸酯（PHA）的合成与应用概述

聚羟基脂肪酸酯（polyhydroxyalkanoates,PHA）是很多微生物合成的一种细胞内聚酯,是一种天然的高分子生物材料。PHA具有良好的生物相容性能、生物可降解性和塑料的热加工等性能。文章主要综述了PHA的合成途径与有关应用方面的研究。     

Selective sorption of perfluorooctane sulfonate on molecularly imprinted polymer adsorbents

Perfluorooctane sulfonate (PFOS), as a potential persistent organic pollutant, has been widely detected in water environments, and has become a great concern in recent years. PFOS is very stable and difficult to decompose using conventional techniques. Sorption may be an attractive method to remove it from water. In this study, the molecularly imprinted polymer (MIP) adsorbents were prepared through the polymerization of 4-vinylpyridine under different preparation conditions in order to remove perfluorooctane sulfonate (PFOS) from water. The MIP adsorbents using perfluorooctanoic acid (PFOA) as the template had good imprinting effects and could selectively remove PFOS from aqueous solution. The sorption behaviors including sorption kinetics, isotherms, and effect of pH, salt, and competitive anions were investigated. Experimental results showed that the sorption of PFOS on the MIP adsorbents was very fast, pH-dependent, and highly selective. The achieved fast sorption equilibrium within 1 h was attributed to the surface sorption on the fine adsorbents. The sorption isotherms showed that the sorption selectivity of PFOS on the MIP adsorbents decreased at high PFOS concentrations, which may be due to the double-layer sorption and the formation of PFOS micelles on the sorbent surface. The sorption of PFOS on the MIP adsorbents was mainly dominated by the electrostatic interaction between the protonated vinylpyridine on the adsorbent surface and the anionic PFOS. The prepared MIP adsorbents can potentially be applied in water and wastewater treatment for selective removal of PFOS.     

油田聚合物驱采出污水絮凝过程研究

针对油田聚合物驱（简称聚驱）采出污水,通过对油滴粒度分布、絮凝指数、油水分离特性和Zeta电位等指标的测定,研究了聚合物、温度、药剂以及搅拌强度对絮凝过程的影响,并探讨了影响聚驱采出污水油水分离效果的主要原因.结果表明,静电排斥并不是聚驱采出污水异常稳定的主要原因. 聚驱采出污水的油水分离特性与水驱采出污水相比存在显著差别,主要因为聚合物阻碍了小油滴的碰撞絮凝. 投加250mg/L由改性聚醚类破乳剂和弱阳离子絮凝剂复合而成的CHP-03药剂,可以有效克服聚合物的阻碍作用,获得92%的含油去除率. 该药剂在絮凝过程中并不依靠电中和机理来实现油滴的脱稳. 在现场条件下,温度的提高不能明显地促进油滴絮凝的有效性. 适当的高速搅拌可以加快絮体生长. 油滴之间的聚结破乳滞后于絮凝,絮凝的后期应避免剧烈搅拌,防止尚未聚结破乳的油滴重新分散.